收到ebaina的Hi3520D板子，show一下

有转送给我用用吗

有 Uboot source code 可以分享嗎 ???

貌似都过去好久了！

你这个板子怎么连接串口啊？求指教

你这个雄迈的板子串口进入终端，能输入信息么？

Starting kernel ...

Uncompressing Linux... done, booting the kernel.我这里一直显示这个不知道怎么回事

[quote][url=forum.php?mod=redirect&goto=findpost&pid=26105&ptid=9946]david 发表于 2016-3-6 21:26[/url]
哈，才看到[/quote]

版主，求指教雄迈的板子怎么烧写系统，开机打印
U-Boot 2010.06-svn198 (Dec 08 2014 - 13:02:43)

Check spi flash controller v350... Found
Spi(cs1) ID: 0xC2 0x20 0x17 0xC2 0x20 0x17
Spi(cs1): Block:64KB Chip:8MB Name:"MX25L6406E"
envcrc 0xec4d696a
ENV_SIZE = 0xfffc
In:    serial
Out:   serial
Err:   serial
USB:   scanning bus for devices... 1 USB Device(s) found
0 Storage Device(s) found
Press CTRL-C to abort autoboot in 0 seconds8192 KiB hi_sfc at 0:0 is now current device

CFG_BOOT_ADDR:0x0
0ff:0x84000000
### /UbootLogo UbootLogoload complete: 21986 bytes loaded to 0x8e800000
jpeg decoding ...
<>
<>
decode success!!!!
decode jpeg success.
decode jpeg!

srcAddr 0x82000000, dstAddr 0x82000000
find_squashfs_file: name bin, start_block 0, offset 1346, type 1
find_squashfs_file: name boot, start_block 0, offset 1434, type 1
read inode: name boot, sb 0, of 1434, type 1
find_squashfs_file: name zImage.img, start_block 0, offset 1378, type 2
read inode: name zImage.img, sb 0, of 1378, type 2
### FS load complete: 1434688 bytes loaded to 0x82000000
## Booting kernel from Legacy Image at 82000000 ...
   Image Name:   linux
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1434624 Bytes = 1.4 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
按了ctrl c没反应，求助啊

求指教怎么重新少烧写系统或者进入雄迈的uboot

貌似都过去好久了！

没有收到，我拿什么秀呢

哈，才看到 :):)

怎么没有图，上个图看下！